Latest 150-130 Practice Tests with Actual Questions

Get Complete pool of questions with Premium PDF and Test Engine

Exam Code : 150-130
Exam Name : Brocade Certified Network Engineer 2012
Vendor Name :
"Brocade"

Download Full Version of 150-130

---

150-130 Dumps

150-130 Braindumps

150-130 Real Questions

150-130 Practice Test

150-130 Actual Questions

killexams.com

Brocade

150-130

Brocade Certified Network Engineer 2012

https://killexams.com/pass4sure/exam-detail/150-130

QUESTION 111

Which three statements are true when configuring virtual routing interfaces? (Choose three.)

1. A single virtual interface can be used to route traffic between all VLANs within the same switch.

2. Each VLAN on a switch requires its own virtual interface.

3. A virtual interface can be a member of multiple VLANs.

4. A virtual interface can have multiple IP addresses.

5. Hosts in a VLAN can use the IP address of the virtual interface as their default gateway.

Correct

Answer: BDE

QUESTION 112

You are configuring multiple VLANs using only untagged ports on two switches. Which statement is true?

1. All traffic between switches will use 802.lq.

2. AII VLAN traffic can use a single untagged uplink port.

3. Untagged ports can be placed into multiple VLANs.

4. Each VLAN requires a dedicated uplink between switches.

Correct

Answer: D

QUESTION 113

Which two statements about LAGs are true? (Choose two.)

1. A LAG provides load-sharing.

2. A LAG provides sub-microsecond failover,

3. A LAG can contain links of different speeds.

4. A LAG is treated as a single logical link by the switch.

Correct

Answer: AD

QUESTION 114

Your company uses OSPF and has recently purchased another company that uses RIP.

Management requires that routes between the two companies be shared without interrupting services on either network. How is this implemented?

1. Enable route redistribution in both RIP and OSPF on the DR.

2. Enable route redistribution in both RIP and OSPF on the BDR.

3. Enable route redistribution in both RIP and OSPF on the ASBR.

4. Enable route redistribution in both RIP and OSPF in the ABR.

Correct

Answer: C

QUESTION 115

What are two valid BPDU types in Spanning Tree 802.1D? (Choose two.)

1. Configuration BPDU

2. Root Override BPDU

3. Failure Notification BPDU

4. Topology Change Notification BPDU

Correct

Answer: AD

QUESTION 116

When using CIDR notation, what is the default route in an IPv6 configuration?

A. ::/0

B. 1001:ffff:0:0:0:0::Vl28

C. 1001:ffff:0:0:0::y0

D. ffff::/36

Correct

Answer: A

answer is right.

QUESTION 117

What are two Brocade stackable products? (Choose two.)

1. Brocade Fastiron SX

2. BrocadeFastIronCX

3. BrocadelCX6430

4. Brocade MLXe

Correct

Answer: BC

great answer.

QUESTION 118

You have just configured a new Multi-Chassis Trunk between two Brocade MLXe chassis.

Which protocol information will be distributed across this link?

1. IPv6

2. BGP

3. RIPv2

4. STP

Correct

Answer: D

good answer.

QUESTION 119

Which two statements about ingress extended ACLs are correct? (Choose two.)

1. They use extended ACL IDs 200 - 299.

2. They save network resources by reducing traffic.

3. They eliminate denial of service (DoS) attacks.

4. They block unwanted traffic or users.

Correct

Answer: BD

QUESTION 120

Which statement is true of an access control list (ACL) on a Brocade IP device?

1. Only outbound ACLs can be used on any Brocade IP device.

2. The ACL takes effect immediately after being applied to an interface.

3. An ACL is immediately applied to all physical interfaces once the ACL is configured.

4. Standard ACLs can be used to control traffic inbound or outbound based on source and destination addresses.

Correct

Answer: B

QUESTION 121

When 802.lp priority override is enabled on the primary port of a trunk group, which other ports of the trunk group will be affected?

1. all ports except the primary trunk port

2. some of the trunk ports

3. only the primary port of the trunk group

4. all ports of the trunk group

Correct

Answer: D

QUESTION 122

What are the three available QoS scheduling algorithms available on Brocade NetIron and FastIron products? (Choose three.)

1. weighted round robin

2. strict priority

3. first-in-first-out

4. hybrid

5. deficit round robin

Correct

Answer: ABD

QUESTION 123

Which QoS mechanism would you use to set the DSCP value specified of an outgoing packet?

1. dscp-cos-mapping

   
   

2. dscp-matching

3. dscp-marking

4. internal-priority-marking

Correct

Answer: C

QUESTION 124

sFlow uses which method to send data to a collector?

1. multicast

2. broadcast

3. TCP port 6343

4. UDP port 6343

Correct

Answer: D

QUESTION 125

Given the command output shown below:

de(config)#mirror-port ethernet 1/2/4 Brocade(config)#interface ethernet 1/2/11 Brocade(config-if-e100-11)#monitor ethernet 1/2/4 both What do the Brocade commands accomplish?

1. They allow all traffic on interface ethernet 1/2/11 to be replicated on interface ethernet 1/2/4 for analysis

2. They allow ingress only traffic on interface ethernet 1/2/4 to be replicated on interface Ethernet 1/2/11 for analysis.

3. They allow all traffic on interface ethernet 1/2/4 to be replicated on interface ethernet 1/2/11 for analysis.

   
   

4. They allow egress only traffic on interface ethernet 1/2/4 to be replicated on interface Ethernet 1/2/11 for analysis.

Correct

Answer: A

User: Tiauna***** Selecting Killexams.com for my 150-130 exam preparation was a wise decision. The patterns and questions were distributed evenly, enabling me to raise my bar by the time I reached the final simulation exam. I appreciate the effort and honesty of the team, and I thank them for their support in helping me pass the exam.

User: Naum***** Due to time constraints, I only had a week to prepare for the 150-130 exam. I turned to killexams.com Questions and Answers, which contained concise responses, for quick reference. Thanks to their comprehensive material, my world changed for the better. The exam Answers they provided were the best option for me given my limited time.

User: Natalia***** I answered all questions in the BROCADE CERTIFIED NETWORK ENGINEER 2012 exam with ease, all thanks to Killexams.com. It is a terrific asset for passing the test, and I advise everyone to use it. I tried several books, but none of them worked for me until I discovered Killexams.com Questions and Answers. The easy-to-understand language and organized questions and answers made it easier for me to plan and prepare for the exam.

User: Taniya***** I just wanted to express my gratitude for your study materials. This was my first time using your cram, and I am pleased to say that I passed the 150-130 exam with an 80% score. While I was initially skeptical, my success in the certification exam is proof of the effectiveness of your materials. Thank you, killexams.com!

User: Senya***** I want to express my gratitude to killexams.com for providing complete help through their questions and answers. I scored 78% on my 150-130 exam, thanks to killexams.com.

---