Latest 4A0-108 Practice Tests with Actual Questions

Get Complete pool of questions with Premium PDF and Test Engine

Exam Code : 4A0-108
Exam Name : Alcatel-Lucent Multicast Protocols
Vendor Name :
"Alcatel-Lucent"

Download Full Version of 4A0-108

---

4A0-108 Dumps

4A0-108 Braindumps 4A0-108 Real Questions 4A0-108 Practice Test

4A0-108 Actual Questions

killexams.com Alcatel-Lucent 4A0-108

Alcatel-Lucent Multicast Protocols

https://killexams.com/pass4sure/exam-detail/4A0-108

Answer: A

Question: 78

How many bits of the IPv4 multicast address directly match bits in the multicast MAC address?

1. 23

2. 25

3. 27

4. 28

Answer: A

Question: 79

What is the destination address of the MLDv2 report message?

1. FF02::1

2. FF02::2 C. FF02::16

D. The specific multicast group address that the host is interested in.

Answer: C

Question: 80

Click the exhibit.

The interface's IGP metric is as shown, and PIM is using the unicast table for the RPF- check. What happens when Router B receives a register message on its interface facing Router A?

1. Router B discards the register message, as the RPF-check fails.

2. Router B forwards the register message to Router D (RP) according to its routing table.

3. Router B forwards the register message out of all the interfaces in its (',239.1.1.1) entry's outgoing interface list.

4. Router B forwards the register message out of all the interfaces in its (192.168.1.1,239.1.1.1) entry's outgoing interface list.

Answer: B

Question: 81

How many types of Auto-Discovery routes are defined for MCAST-VPN NLRI?

1. 3

2. 5

3. 7

4. 9

Answer: C

Question: 82

What is the default version of IGMP on the Alcatel-Lucent 7750 SR?

1. Version 1

2. Version 2

3. Version 3

4. There is no default setting, you must configure the version when you enable IGMP on 7750 SR

Answer: C

Question: 83

Click the exhibit.

The network administrator of 2001 ;DB8:FEED::/64 wants to embed an RP for the network. The RP's address is 2001:DB8:FEED::7. Which of the following multicast address ranges would suit this purpose? (The exhibit shows the group-to-RP mapping for your reference only.)

1. FF7x:730:2001:DBS:FEED::/96 (x is scope)

2. FF7x:730:2001:DBS:FEED::/80 (x is scope) C. FF7x: 740:2001:DB8:FEED::/96 (x is scope) D. FF7x:740:2001:DB8:FEED::/80(x is scope)

Answer: C

Question: 84

Click the exhibit.

Based on the output, which of the following is correct?

1. The S-PMSI group address is 239.1.1.10.

2. The I-PMSI group address is 239.1.1.10.

3. The S-PMSI group address is 239.1.1.20.

4. The I-PMSI group address is 239.1.1.20.

Answer: C

Question: 85

Which of the following is NOT a benefit of multicast for delivering data to multiple receivers?

1. Its data delivery is more efficient than unicast and broadcast.

2. It is more scalable than unicast and broadcast.

3. It suits VoD (Video on Demand) services very well.

4. It suits BTV (Broadcast TV) services very well.

Question: 86

In Draft Rosen, a PE router encapsulates customer multicast packets into provider packets. What source IP address is used for the provider packets?

1. The system IP address of the originating PE router.

2. The source IP address of the customer packet.

3. The outgoing interface IP address of the originating PE router.

4. The source IP address specified in the MVPN configuration.

Answer: A

Question: 87

What is the advantage of using the S-PMSI over the I-PMSI in Draft Rosen?

1. The S-PMSI reduces control plane overhead because the I-PMSI is no longer needed.

2. The S-PMSI only forwards customer multicast traffic to PEs that have interested receivers.

3. The S-PMSI is required because it is the initial multicast distribution tree for the MVPN.

4. The S-PMSI encapsulates customer multicast traffic in an MPLS tunnel, which is more efficient than the GRE tunnel used by the I-PMSI.

Answer: B

Question: 88

Which of the following regarding VRF Route Import extended community is TRUE?

1. It is used to support UMH selection in Inter-AS MVPN.

2. It is a new extended community added only to MVPN multicast routes.

3. It contains Global Administrator and Local Administrator fields.

4. It contains the AS number of the source PE.

Answer: C

Question: 89

A BSR candidate message is seen with a higher priority than the existing BSR. Which of the following describes the action that occurs?

1. The higher priority router becomes the BSR only after the existing BSR fails.

2. The higher priority router becomes the BSR after the bootstrap message wait interval.

3. The higher priority router becomes the BSR immediately.

4. There is a BSR configuration parameter that determines whether or not there is a BSR election in this case.

Answer: C

Question: 90

Which of the following is NOT an advantage of NG MVPN over Draft Rosen?

1. MP-BGP is more scalable than PIM.

2. Unicast and multicast traffic in the same VPRN service can use the same transport tunnel.

3. P routers in the core do not need to maintain any PIM group states.

4. An MPLS tunnel can be used instead of a GRE tunnel.

Answer: D

Question: 91

Click the exhibit.

1. The S-PMSI is instantiated by MPLS tunnels.

2. The S-PMSI group address range is 232.10.10.0/24.

3. 192.168.1.2 is the system IP address of the source PE.

4. The customer is sending multicast traffic to group 239.1.1.1.

Answer: D

Question: 92

Which of the following services is provided by the use of PIM as a multicast routing protocol?

1. Authentication

2. Guaranteed delivery

3. Device security

4. Prevention of forwarding loops

5. Prevention of Denial of Service attacks

Answer: D

Question: 93

Click the exhibit.

What happens when the displayed router receives an IGMPv3 exclude none report for group 232.1.1.1?

1. The router propagates a (:,:, 232.1.1.1) join towards RP if it exists.

2. The router sends a PIM (S, G) join toward both sources: 192.168.1.1 and

   192.168.1.2.

3. The IGMPv3 report is dropped and a misconfiguration message is generated in log 99.

4. The router sends a PIM (192.168.1.1, 232.1.1.1) join toward the source.

Answer: D

Question: 94

Which of the following regarding the BSR and the RP is TRUE?

1. A router cannot be configured as a BSR-candidate and a static RP at the same time.

2. A router cannot be a candidate-RP and a BSR-candidate at the same time.

3. There is only one active RP in a multicast routing domain at any time.

4. There is only one elected BSR in a multicast routing domain at any time.

Answer: D

Question: 95

The Draft-Rosen S-PMSI address range is configured for 32 group addresses. What happens if there are more than 32 customer multicast flows that exceed the threshold configured for the MVPN?

1. Traffic for the 33rd multicast flow is dropped.

2. Traffic for the 33rd multicast flow is transmitted on the I-PMSI.

3. The source PE reassigns the S-PMSI with the smallest flow to the new multicast flow. Traffic for the smaller flow is transmitted on the I-PMSI.

4. The source PE re-uses an S-PMSI that is currently in use for the 33rd flow. Traffic for both flows is sent on the same S-PMSI.

Answer: D

Question: 96

Which of the following is NOT a characteristic of Draft Rosen?

1. PIM in the VRF.

2. PIM in the service provider's core network.

3. GRE encapsulation for multicast data traffic.

4. MPLS encapsulation for multicast data traffic.

Question: 97

Which protocol is used to establish the I-PMSI in Draft Rosen?

1. PIM DM

2. PIM ASM

3. PIM SSM

4. Either PIM ASM or PIM SSM

Answer: B

User: Virginia***** Passing my 4A0-108 exam was crucial for me to retain my job in my current company, and it was not an easy task without some help. Thanks to the Killexams.com preparation pack, which included 4A0-108 questions answers and an exam simulator, I learned so much and passed my 4A0-108 exam with pride. Great work, Killexams.com.

User: Stepka***** Before starting my private IT enterprise, I needed 4a0-108 certification to enhance my business. I took admission for 4a0-108 certification and attended lectures, but I did not understand anything. After searching for a solution, I found Killexams.com, where I learned everything I needed to know. I also passed my 4a0-108 exam with excellent marks, which is a testament to the effectiveness of Killexams.com.

User: Lillian***** I passed the 4a0-108 exam on my first attempt, thanks to Killexams.com questions and answers. The package helped me utilize my work knowledge in a question and answer format. I used an exam simulator to answer the query papers and got a complete idea of the exam paper. I would like to thank Killexams for their valuable support.

User: Charles***** I mostly used a mix of books to prepare for the exam. The questions in the Killexams.com material matched the exam questions accurately, which was incredibly helpful. I passed the exam with 89% marks about a month ago. Whoever tells you that 4A0-108 is too hard, do not believe them. The exam is tough, but using Killexams.com Questions and Answers and exam simulator as my sole source of preparation was the key to my success.

User: Ximena***** I no longer feel alone when it comes to exam preparation, thanks to killexams.com. They not only provide me with excellent test material, but also offer instructors who are ready to guide me at any time of the day. Throughout my test, I received the same level of support and guidance, and all my questions were responded to. I am grateful to the experts here for being excellent and helping me pass my challenging exam with 4A0-108 test material, 4A0-108 exam, and even 4A0-108 exam simulator.

---