4A0-105 : Alcatel-Lucent Virtual Private LAN Services Exam

4A0-105 Dumps
4A0-105 Braindumps
4A0-105 Real Questions
4A0-105 Practice Test
4A0-105 Actual Questions


Alcatel-Lucent
4A0-105
Alcatel-Lucent Virtual Private LAN Services
https://killexams.com/pass4sure/exam-detail/4A0-105
A. The frame will be forwarded outthe port associated with the DA.
B. The frame will be discarded.
C. The frame will be flooded to all ports.
D. The frame will be fragmented and forwarded outthe port associated with the DA.
Answer: B
QUESTION: 144
A router has just learned the 10th MAC address while the FDB size is also set to 10. What is
the likely outcome?
A. The frame is dropped.
B. The frame is always flooded
C. The frame is forwarded and MAC learning is automatically disabled.
D. The frame is discarded if the destination is unknown.
E. More information is required to determine the fate of this new frame.
Answer: C
QUESTION: 145
Which of the following must be true in order to add a port to a LAG? (Choose 2)
A. ports must be on the same MDA
B. ports must have the same speed and duplex settings
C. autonegotiationmustbeon
D. autonegotiation must be off or limited
E. port must be in access mode only
Answer: B, D
QUESTION: 146
How does PBB forward broadcast, unknown-unicast and multicast traffic from a B-VPLS to
an l-VPLS?
A. The receiving PE checks the l-TAG in the l-SID to determine if there is a local l-VPLS
on the node.
B. The receiving PE checks the l-SID in the l-TAG to determine if there is a local l-VPLS
on the node.
C. The receiving PE checks the service label in the mpls header to determine if there is a
local l-VPLS on the node.
D. The receiving PE checks the multicast B-DA to see if an l-SID has been mapped to the
B-DA that matches a local l-VPLS on the node.
Answer: D
QUESTION: 147
An MC-LAG is configured with default parameters. When a failed interface recovers, the
active link reverts to the restored interface.
A. TRUE
B. FALSE
Answer: B
QUESTION: 148
The following question relates to this command syntax: "config>service# vpls 9000
customer 6 create". Which of the following statements are correct? (Choose 2)
A. The customer-id in this command is 9000.
B. The service-id in this command is 9000.
C. This value 9000 should be unique across the network as a best practice.
D. The vc-id will be 6 for the service by default.
E. The egress vc-label will be 9000.
Answer: B, C
QUESTION: 149
Which of the following statements about a management VPLS are true? (Choose 2)
A. A management VPLS carries customer traffic over the non-blocking spoke-SDP
B. A VPLS service must be defined as a management VPLS upon creation to take on the
role of a management VPLS
C. The state of a spoke-SDP within a user VPLS will take on the state of the spoke-sdp
within the management VPLS.
D. The management VPLS must be created before the user VPLS.
Answer: B, C
QUESTION: 150
What action will be taken when an MPLS router receives a frame with a label that does not
exist in the LFIB?
A. The frame will be flooded.
B. The frame will be discarded.
C. The frame will be fragmented.
Answer: B
QUESTION: 151
An l-VPLS can be associated with many B-VPLS services.
A. TRUE
B. FALSE
Answer: B
QUESTION: 152
Click on the exhibit below.
Assume PE-B expects avian tag as part of the RFC 4762 (Martini) encapsulation. How must
PE-A be configured?
A. The port that the SAP belongs to must have the correct ether type configured.
B. The SAP must be configured with the right VLAN tag.
C. The SDP VC type must be configured as type VLAN and the correct vlan-vc-tag must be
specified.
D. All of the above.
Answer: C
QUESTION: 153
An l-VPLS is configured with a service id of 511. What will the value of the l-SID be
assuming a default configuration?
A. The 1-SID must be explicitly configured.
B. The 1-SID only supports a range from 1 to 255.
C. The 1-SID will default to 511 .the value of the service-id.
D. Thel"SIDwilldefaultto131582,thevalueoftheservice-id + 131071.
Answer: C
QUESTION: 154
In RSTP, how is the root bridge selected?
A. The switch with the highest bridge-id is selected as root.
B. The switch with the lowest bridge-id is selected as root.
C. The switch with the highest MAC address is selected as root
D. The switch with the lowest MAC address is selected as root.
Answer: B
QUESTION: 155
Which of the following needs to be considered when designing Ethernet networks with
redundancy?
A. Processing the TTL takes extra time.
B. MAC learning rate is doubled.
C. FDB size is doubled.
D. Requires a protocol to remove loops.
Answer: D
QUESTION: 156
Click on the exhibit below.


A new router named PE-D is to be directly connected to PE-C and is required to be added to
the existing VPLS 300. The design requires the least amount of signaling, the least amount
of configuration changes for existing sites and the new site has to have access to all existing
sites. How should the new site be added to VPLS 300?
A. Configure a mesh-sdp between all existing PE routers and the new PE router
B. Configure a mesh-sdp between PE-C and PE-D
C. Configure a spoke-sdp between PE-C and PE-D.
D. It is not possible to meet the design requirements.
Answer: C

User: Leni***** I highly recommend Killexams.com to anyone considering purchasing exam preparation materials. It is a fully valid and reliable preparation tool and a great option for those who cannot afford full-time courses. I believe those are a waste of time and money, especially when Killexams.com is available. And in case you were wondering, the questions are real!

User: Nettie***** The 4a0-105 exam was challenging, with many complex topics to master. Killexams.com boosted my confidence by providing accurate answers to even the most twisted questions. Their study guide was instrumental in helping me navigate the exam successfully.

User: Pat***** I am thrilled to share that I passed my 4a0-105 exam with confidence, thanks to the exceptional preparation materials from killexams.com. Their practice tests were thorough and user-friendly, covering all the essential topics I needed to master. The clarity and quality of their resources gave me the edge I needed to succeed, and I am deeply appreciative of their outstanding support.

User: Abd***** I once doubted my ability to pass the 4A0-105 exam, but Killexams.com changed that. Their resources provided the clarity and confidence I needed to succeed. I am now a certified professional, thanks to their support.

User: Rayna***** I am immensely grateful for killexams.com’s 4a0-105 practice testprep materials, which served as my primary study tool and led to a 95% score on the exam. Repeatedly practicing with their exam simulator until I was fully confident was key to my success. I have enthusiastically recommended their platform to my friends, confident they will find it as transformative as I did, and I am to their exceptional resources.

---