NSE7_SDW-7.0 : Fortinet NSE 7 - SD-WAN 7.0 Exam

NSE7_SDW-7.0 Dumps
NSE7_SDW-7.0 Braindumps
NSE7_SDW-7.0 Real Questions
NSE7_SDW-7.0 Practice Test
NSE7_SDW-7.0 Actual Questions


Fortinet
NSE7_SDW-7.0
Fortinet NSE 7 - SD-WAN 7.0
https://killexams.com/pass4sure/exam-detail/NSE7_SDW-7.0

Question: 151
Refer to the exhibits.

Two hub-and-spoke groups are connected through a site-to-site IPsec VPN between Hub 1 and Hub 2. The
administrator configured ADVPN on both hub-and-spoke groups.
Which two outcomes are expected if a user in Toronto sends traffic to London? (Choose two.)
A. London generates an IKE information message that contains the Toronto public IP address.
B. Traffic from Toronto to London triggers the dynamic negotiation of a direct site-to-site VP
C. Toronto needs to establish a site-to-site tunnel with Hub 2 to bypass Hub 1.
D. The first packets from Toronto to London are routed through Hub 1 then to Hub 2.
Answer: A,B,C
Question: 152
Which two performance SLA protocols enable you to verify that the server response contains a specific value?
(Choose two.)
A. http
B. icmp
C. twamp
D. dns
Answer: A,D
Explanation:
Pages 85,86 in Study guide 7.0 Pages 100,101 in Study guide 7
Question:
Refer to the exhibits.

Which two conclusions for traffic that matches the traffic shaper are true? (Choose two.)
A. The traffic shaper drops packets if the bandwidth is less than 2500 KBps.
B. The measured bandwidth is less than 100 KBps.
C. The traffic shaper drops packets if the bandwidth exceeds 6250 KBps.
D. The traffic shaper limits the bandwidth of each source IP to a maximum of 6250 KBps.
Answer: A,B,C
Question: 154
Refer to the exhibit.

Which configuration change is required if the responder FortiGate uses a dynamic routing protocol to exchange routes
over IPsec?
A. type must be set to static.
B. mode-cfg must be enabled.
C. exchange-interface-ip must be enabled.
D. add-route must be disabled.
Answer: D
Explanation:
for using "non ike" routes (for example BGP/static and so on) you must do disable the add-route that
inject automatically kernel route based on p2 selectors from the remote site from the SD-WAN_7.2_Study_Guide page
236
Question: 155
Which CLI command do you use to perform real-time troubleshooting for ADVPN negotiation?
A. get router info routing-table all
B. diagnose debug application ike
C. diagnose vpn tunnel list
D. get ipsec tunnel list
Answer: B
Explanation:
IKE real-time debug - useful when debugging ADVPN shortcut messages and spoke-to-spoke negotiations.
βΆ diagnose debug console timestamp enable
βΆ diagnose vpn ike log filter clear
βΆ diagnose vpn ike log filter mdst-addr4
βΆ diagnose debug application ike -1
βΆ diagnose debug enable
Question: 1
Refer to the exhibits.


Exhibit B
Exhibit A shows the system interface with the static routes and exhibit B shows the firewall policies on the managed
FortiGate.
Based on the FortiGate configuration shown in the exhibits, what issue might you encounter when creating an SD-
WAN zone for port1 and port2?
A. port1 is assigned a manual IP address.
B. port1 is referenced in a firewall policy.
C. port2 is referenced in a static route.
D. port1 and port2 are not administratively down.
Answer: B
Question: 157
Which two statements are correct when traffic matches the implicit SD-WAN rule? (Choose two.)
A. The sdwan_service_id flag in the session information is 0.
B. All SD-WAN rules have the default setting enabled.
C. Traffic does not match any of the entries in the policy route table.
D. Traffic is load balanced using the algorithm set for the v4-ecmp-mode setting.
Answer: A,C
Explanation:
sdwan_service_id is 0 = match SD-WAN implicit rule, study guide 7.0 page 120, 7.2 page 149 SD-WAN rules
internally are interpreted as a Policy route, so when the traffic doesn't match with any policy route, it will be flowing
by implict policy.
Question: 1
Refer to the exhibit.


An administrator is troubleshooting SD-WAN on FortiGate. A device behind branch1_fgt generates traffic to the
10.0.0.0/8 network. The administrator expects the traffic to match SD-WAN rule ID 1 and be routed over
T_INET_0_0. However, the traffic is routed over T_INET_1_0.
Based on the output shown in the exhibit, which two reasons can cause the observed behavior? (Choose two.)
A. The traffic matches a regular policy route configured with T_INET_1_0 as the outgoing device.
B. T_INET_1_0 has a lower route priority value (higher priority) than T_INET_0_0.
C. T_INET_0_0 does not have a valid route to the destination.
D. T_INET_1_0 has a higher member configuration priority than T_INET_0_0.
Answer: A,C
Explanation:
https://community.fortinet.com/t5/FortiGate/Technical-Tip-Assigning-Priority-to-SD-WAN-Members-for-Default/ta-
p/230911
Question: 1
Refer to the exhibit.
Based on the exhibit, which two actions does FortiGate perform on sessions after a firewall policy change? (Choose
two.)
A. FortiGate flushes all sessions.
B. FortiGate terminates the old sessions.
C. FortiGate does not change existing sessions.
D. FortiGate evaluates new sessions.
Answer: A,C,D
Explanation:
FortiGate not to flag existing impacted session as dirty by setting firewall-session-dirty to check new.
The results is that FortiGate evaluates only new session against the new firewall policy.
Question: 160
Which two statements about SD-WAN central management are true? (Choose two.)
A. The objects are saved in the ADOM common object database.
B. It does not support meta fields.
C. It uses templates to configure SD-WAN on managed devices.
D. It supports normalized interfaces for SD-WAN member configuration.
Answer: A,C
Explanation:
Normalized interfaces are not supported for SD-WAN templates. You can create multiple SD-WAN zones and add
interface members to the SD-WAN zones. You must bind the interface members by
name to physical interfaces or VPN interfaces. https://docs.fortinet.com/document/fortigate/7.0.0/sd-wan-new-
features/794804/new-sd-wan-template-fmg
Question: 161
Refer to the exhibits.
Which conclusion about the packet debug flow output is correct?
A. The total number of daily sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured
in the traffic shaper, and the packet was dropped.
B. The packet size exceeded the outgoing interface MT
C. The number of concurrent sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured
in the traffic shaper, and the packet was dropped.
D. The number of concurrent sessions for 10.1.10.1 exceeded the maximum number of concurrent sessions configured
in the firewall policy, and the packet was dropped.
Answer: A,C
Explanation:
In a Per-IP shaper configuration, if an IP address exceeds the configured concurrent session limit, the message
"Denied by quota check" appears. SD-WAN 7.0 Study Guide page 287
Question: 162
Which are two benefits of using CLI templates in FortiManager? (Choose two.)
A. You can reference meta fields.
B. You can configure interfaces as SD-WAN members without having to remove references first.
C. You can configure FortiManager to sync local configuration changes made on the managed device, to the CLI
template.
D. You can configure advanced CLI settings.
Answer: A,D
Question: 163
What is the route-tag setting in an SD-WAN rule used for?
A. To indicate the routes for health check probes.
B. To indicate the destination of a rule based on learned BGP prefixes.
C. To indicate the routes that can be used for routing SD-WAN traffic.
D. To indicate the members that can be used to route SD-WAN traffic.
Answer: B
Question: 164
Refer to the exhibit.


The exhibit shows the SD-WAN rule status and configuration.
Based on the exhibit, which change in the measured latency will make T_MPLS_0 the new preferred member?
A. When T_INET_0_0 and T_MPLS_0 have the same latency.
B. When T_MPLS_0 has a latency of 100 ms.
C. When T_INET_0_0 has a latency of 250 ms.
D. When T_N1PLS_0 has a latency of 80 ms.
Answer: D
Question: 165
Refer to the exhibits.
Exhibit A -





Exhibit B -


Exhibit A shows the traffic shaping policy and exhibit B shows the firewall policy.
The administrator wants FortiGate to limit the bandwidth used by YouTube. When testing, the administrator
determines that FortiGate does not apply traffic shaping on YouTube traffic.
Based on the policies shown in the exhibits, what configuration change must be made so FortiGate performs traffic
shaping on YouTube traffic?
A. Destination internet service must be enabled on the traffic shaping policy.
B. Application control must be enabled on the firewall policy.
C. Web filtering must be enabled on the firewall policy.
D. Individual SD-WAN members must be selected as the outgoing interface on the traffic shaping policy.
Answer: B
Question: 166
Refer to the exhibit, which shows the IPsec phase 1 configuration of a spoke.

What must you configure on the IPsec phase 1 configuration for ADVPN to work with SD-WAN?
A. You must set ike-version to 1.
B. You must enable net-device.
C. You must enable auto-discovery-sender.
D. You must disable idle-timeout.
Answer: B

User: Kodiak***** I owe a debt of gratitude to Killexams.com for providing such high-quality exam practice tests. The nse7_sdw-7.0 exam practice tests were valid and helped me achieve a 95% score. I plan to return for additional test prep and highly recommend Killexams.com to anyone looking for comprehensive study materials.

User: Fatima***** In my pursuit of certification for the nse7_sdw-7.0 exam, I chose to use Killexams.com questions and answers. Their material was exceptionally well-organized, and I found it particularly useful for topics such as statistics gathering and desires in the nse7_sdw-7.0 exam. I completed all the questions in nearly an hour and 20 minutes, receiving a score of 89. I extend my sincere thanks to Killexams for their invaluable help.

User: Frederick***** I highly recommend the killexams.com questions and answers to my colleagues and partners. They are all extremely satisfied with the results they have achieved using this study material. Thanks to killexams.com, my professional performance has improved, and I was able to effectively prepare for my exams. I am a big fan of killexams.com and consider them to be the best training provider.

User: Slavka***** I used to be lazy and always looked for shortcuts and easy techniques. During my IT course on NSE7_SDW-7.0, I found it very challenging and could not find any guidelines. That is when I heard about killexams.com, which is very famous in the market. The sample and practice questions helped me prepare for the NSE7_SDW-7.0 exam, and I secured suitable marks. All thanks to killexams.com.

User: Lilia***** I recently came across the best IT exam preparation material I have ever used. Even though my NSE7_SDW-7.0 exam is just a few days away, I feel fully prepared and confident, especially since I have access to all the helpful resources here. The exam simulator is very useful, making it easy to remember questions and answers. Additionally, if you go through them repeatedly, you start to understand the concepts better and see the bigger picture. My experience with Killexams has been great so far!

---