E20-555 : silon Solutions and Design Specialist for Technology Architects Exam

E20-555 Dumps
E20-555 Braindumps
E20-555 Real Questions
E20-555 Practice Test
E20-555 Actual Questions


DELL-EMC
E20-555
silon Solutions and Design Specialist for Technology
Architects
https://killexams.com/pass4sure/exam-detail/E20-555
QUESTION: 146
An Isilon customer has a replication policy setup between a primary cluster and a
secondary cluster. After the initial synchronization of the clusters, the primary
cluster starts to exhibit issues so the customer initiates a failover operation between
the two clusters. During the failover, the primary cluster becomes fully operational
again. The customer would like to stop the failover operation between the two
clusters. What is the best way to stop the failover operation and continue using the
primary cluster?
A. Initiate a failover revert on the secondary cluster
B. Initiate a failover revert on the primary cluster
C. Nothing; this is an automatic process
D. Delete the primary clusters' snapshot of this data
Answer: A
QUESTION: 147
An Isilon customer created a scheduled SyncIQ policy to replicate data from an
Enterprise-mode SmartLock directory. The source cluster becomes unusable.
The target cluster does not automatically allow writes to the data in the replicated
SmartLock directory. What is the most likely reason the target cluster did not
automatically allow writes of the data into the SmartLock directory?
A. SyncIQ Automated failover is not supported for SmartLock directories; however,
manual failover is allowed.
B. Automated failover and manual failover are not allowed on SmartLock directories
on the target cluster.
C. A SyncIQ job was running while the source cluster became unusable, thereby
removing all data in the target directory.
D. SnapshotIQ was not licensed on the target cluster; the snapshot of the directory is
not available for use by SyncIQ.
Answer: A
QUESTION: 148
An Isilon customer has two 5-node clusters; one for production and one for disaster
recovery (DR). The customer's workflows are replicated to the DR cluster through
SyncIQ on individual schedules. They shutdown their production cluster for a
scheduled DR test, failed over to the DR cluster, and continue their DR testing.
Assume both clusters have identical shares, exports, and user authentication and
68
that the client applications have been stopped and the DNS re-pointed. What is the
correct method to continue production operations?
A. Revert the SyncIQ Policy
B. Initiate Manual Failback of the SyncIQ Policy
C. Initiate Automated Failback of the SyncIQ Policy
D. No change to the SyncIQ Policy
Answer: A
QUESTION: 149
An Isilon customer has two 5-node clusters, one for production and one for disaster
recovery (DR). The customer's workflows are replicated to the DR cluster through
SyncIQ on individual schedules. They have shutdown their production cluster for
scheduled maintenance, failed over to the DR cluster, and are currently operating
from the DR site. Assume both clusters have identical shares, exports, user
authentication, and that the client applications have been stopped and the DNS re-
pointed. What is the easiest method to continue operations on production?
A. Initiate Automated Failback of the SyncIQ Policy
B. Revert the SyncIQ Policy
C. Initiate Manual Failback of the SyncIQ Policy
D. No change to the SyncIQ Policy
Answer: A
QUESTION: 150
How many file systems are present in a 20-node Isilon X200 cluster?
A. 1
B. 2
C. 3
D. 4
Answer: A
QUESTION: 151
69
Which type(s) of data is predominately associated with home directories and file
shares?
A. E-mail files, PPT, Word documents
B. Oracle directories
C. SQL database files
D. XML data
Answer: A
QUESTION: 152
Traditional NAS storage architecture deploys simple two-way failover between two
controllers in their storage systems, such as highly-available configurations. How is
the Isilon architecture different in terms of system resiliency and availability?
A. Isilon OneFS enables each node to have a designated partner node for simple
failover between the pair.
B. Isilon solutions can enable failover to other nodes with the use of client-side
drivers.
C. Isilon clustered architecture deploys standby failover nodes to ensure the highest
available solution.
D. Isilon OneFS enables each node to be a peer to any other node in an Isilon cluster.
Answer: D
QUESTION: 153
If a client is mounted to the sixth node in a 20-node Isilon cluster, how much
memory cache can that client leverage assuming each node has 8 GB of memory
cache?
A. 16 GB
B. 40 GB
C. 120 GB
D. 160 GB
Answer: D
QUESTION: 154
70
What is the maximum volume or aggregate size that can be created with an Isilon
Scale-Out NAS system?
A. 16 TB
B. 100 TB
C. 2.3 PB
D. 20 PB
Answer: D
QUESTION: 155
Which Isilon product is recommended where low-latency and maximum
performance is a critical factor?
A. X-Series
B. S-Series
C. SmartQuotas
D. NL-Series
Answer: B
QUESTION: 156
Refer to Exhibit below:
What is represented by the information shown in the exhibit?
A.
Directory quota cannot exceed 2 TB for both /ifs/data/media and
/ifs/data/media/photo. Directory quota cannot exceed 900 GB for
/ifs/data/media/video.
Directory quota can be any size up to 2 TB and each user can only store 75
GB for
/ifs/data/media/temp.
B.
TB
Directory quota cannot exceed 2 for /ifs/data/media and no quota
limit on
/ifs/data/media/photo.
Directory quota cannot exceed 900 GB for /ifs/data/media/video.
Directory quota can be any size up to 2 TB and each user can only store 75
GB for
71
/ifs/data/media/temp.
C.
Directory quota cannot exceed 2 TB for both /ifs/data/media and
/ifs/data/media/photo. Directory quota cannot exceed 900 GB for
/ifs/data/media/video.
Directory quota can be any size up to 2 TB for /ifs/data/media/temp.
D.
Directory quota cannot exceed 2 TB for both /ifs/data/media and
/ifs/data/media/photo. Directory quota cannot exceed 900 GB for
/ifs/data/media/video.
Directory quota can be any size up to 900 GB and each user can only store
75 GB for
/ifs/data/media/temp.
Answer: A



72

User: Sonia***** I was struggling with my knowledge of the E20-555 exam and needed a smooth guide to help me prepare. The language and explanations provided in killexams.com brain practice tests were simple and concise, making it easy for me to wrap up my training in just 3 weeks. Thanks to them, I passed with flying colors and did not have to read any books filled with long lines and complex language that made me sleepy.

User: Liya***** I am ecstatic to have passed my E20-555 cert exam with a score of 97%. The Killexams.com exam simulator and study material were crucial to my success. Thank you!

User: Stephanie***** After spending sufficient time studying the materials, I passed the E20-555 exam. Although the materials were brain practice tests, they were constructed using actual exam content. I do not understand why some people complain about the questions being different. While not all questions were identical, the topics and overall method were correct. With enough hard work, anyone can excel with Killexams.com.

User: Lera***** I was in a rush to pass the e20-555 exam and obtain my certificate, so I turned to online resources for help. Thats when I stumbled upon killexams.com, and it became my go-to study guide. The site helped me pass the exam, and I am grateful for their reliable and clear study material.

User: Connie***** I can vouch that Killexams.com material is reliable, as I passed the e20-555 exam with over 90% correct answers. The questions in their material are regularly updated, and the company has helped me more than once. As a regular user, I hope to receive a discount for my next package deal.

---