Latest DEA-5TT2 Practice Tests with Actual Questions

Get Complete pool of questions with Premium PDF and Test Engine

Exam Code : DEA-5TT2
Exam Name : Associate - Networking
Vendor Name :
"DELL-EMC"

Download Full Version of DEA-5TT2

---

DEA-5TT2 Dumps DEA-5TT2 Braindumps

DEA-5TT2 Real Questions DEA-5TT2 Practice Test DEA-5TT2 Actual Questions

killexams.com

DELL-EMC

DEA-5TT2

Associate - Networking

https://killexams.com/pass4sure/exam-detail/DEA-5TT2

Question: 208

In which Spanning Tree protocol state does a port record MAC addresses but does not forward the data?

1. Forwarding

2. Blocking

3. Learning

4. Listening

Answer: C
Question: 209

Which port type should be used for only VLAN-unaware devices?

1. Access port

2. General port

3. Hybrid port

4. Trunk port

Answer: A
Question: 210

Which Ethernet frame forwarding method works best when the outbound ports run at the same speed as the inbound port?

1. Store-and-forward

2. Fragment-free

3. Unicast

4. Cut-through

Answer: D
Question: 211

Which port type does a Dell EMC Networking N-Series switch have for its console connection?

1. DB9

2. RJ-45

3. USB A

4. USB B

Answer: A

Explanation:

Reference: https://downloads.dell.com/manuals/all-products/esuprt_ser_stor_net/esuprt_networking/esuprt_net_fxd_prt_swtchs/networking-n3100- series_user%27s-guide10_en-us.pdf page 197

Question: 212

Which type of domains are connected by a Layer 2 switch?

1. Single collision domain and a single broadcast domain

2. Multiple broadcast domains and multiple collision domains

3. Multiple collision domains and a single broadcast domain

4. Single collision domain and multiple broadcast domains

Answer: C
Question: 213

Which component translates data, signaling, and protocols to facilitate the data flow between the end device and the network?

1. Switch

2. Transceiver

3. NIC

4. Port

Answer: C
Question: 214

A network administrator created three VLANs on an Ethernet switch. How many broadcast domains are created by the switch?

1. 1

2. 2

3. 3

4. 4

Answer: C
Question: 215

Which fields are mandatory TLVs in a LLDP PDU frame?

1. System Capabilities and Management Address

2. Chassis ID, Port ID, and Time-to-Live

3. IP Address, Default Gateway, and DNS

4. Port Description, System Name, and System Description

Answer: B

Explanation: Reference:

https://en.wikipedia.org/wiki/Link_Layer_Discovery_Protocol#:~:text=Each%20LLDP%20frame%20starts%20with,and%20length%20fields%20are%200

Question: 216

When configuring a switch, which CLI mode only supports limited show commands?

1. EXEC

2. Maintenance

3. Configuration

4. EXEC Privilege

Answer: D

Explanation:

When configuring a switch, the EXEC Privilege mode, also known as Privileged EXEC mode, only supports limited show commands. This mode provides elevated privileges for executing certain privileged operations and commands on the switch. It allows the user to perform tasks such as viewing system information, running diagnostic commands, and managing system configuration. However, it does not provide access to all show commands and configuration options available in the Configuration mode. To access the full range of show commands and make configuration changes, the user would need to enter the Configuration mode.

Question: 217

On which Dell EMC Networking switches can Multi-Chassis Link Aggregation (MLAG) be configured?

1. C9000 Series

2. N-Series

3. S-Series

4. Z-Series

Answer: B
Question: 218

On which OSI layers do standard ACL filters operate?

1. 2 and 3

2. 2 and 7

3. 3 and 4

4. 4 and 7

Answer: C
Question: 219

What is the Organizationally Unique Identifier (OUI) in the MAC address 00:C4:4F:23:AF:4A?

A. 00:C4:4F

B. 00:C4:4F:23

1. 23:AF:4A

2. 4F:23:AF:4A

Answer: A
Question: 220

What are Network Address Translation (NAT) inside global addresses?

1. Addresses used by NAT router when sending frames to devices on the local network

2. Public IP addresses used by the local network to communicate with the Internet

3. Private IP addresses used by the local network

4. Pubic addresses used by other networks outside of the local network

Answer: B
Question: 221

Which BASE-T Ethernet standard specifies a CAT6 cable type?

1. 2.5GBASE-T

2. 5GBASE-T

3. 10BASE-T

4. 10GBASE-T

Answer: D
Question: 222

Which Dell EMC Networking M-Series 10 GbE switch model supports a VLT?

A. MXL B. M6220 C. M6348

D. M8024-K

Answer: A

Explanation:

Reference: https://i.dell.com/sites/doccontent/shared-content/data-sheets/en/Documents/PowerEdge_M_Series_Blades_IO_Guide.pdf

Question: 223

DRAG DROP

The IEEE separates the Data Link and Physical ISO layers into four sub-layers.

Based on the exhibit, what is the correct order of these sub-layers; from lowest to highest?

wrong

Answer: A
Question: 224

If a packet is sent to an IPv6 address and many devices receive the packet, what is this type of traffic?

1. Multicast

2. Broadcast

3. Anycast

4. Unicast

Answer: A
Question: 225

You recently joined a company as a junior-level network administrator. You have been tasked with designing the IPv4 scheme for five networks that will be used for training classrooms. These networks need to support no more than 28 devices each. Due to the existing network design, the senior-level network administrator has asked you to work on network 192.168.40.0/24.

If all networks must be made to logically start with the lowest numbered network and end with the largest numbered network, what is the network ID for the third network?

A. 192.168.40.32/27 B. 192.168.40.64/27 C. 192.168.40.96/27 D. 192.168.40.128/27

Answer: B
Question: 226

Which IPv6 scope is used for private addressing on a local network?

1. Global

2. Area wide

3. Unique local

4. APIPA

Answer: C
Question: 227

What is the default OSPF âhello intervalâ?

1. 5 seconds

2. 10 seconds

3. 15 seconds

4. 30 seconds

Answer: B

User: Tasha***** I am now associate - networking certified, and I owe it all to the killexams.com associate - networking exam simulator. This exam simulator was tailor-made, keeping in mind the needs of the students who face difficulties while taking the associate - networking exam. The comprehensive engine covers all topics in detail to keep the students informed about every piece of information that will be on the exam. killexams.com understands the best way to keep students assured and ever-prepared for the exam.

User: Umar***** I want to give a heartfelt thanks to Killexams.com for their questions and answers material for the dea-5tt2 exam. It helped me feel confident in my abilities and stand out in the test. The guide was accurate, and I felt that the team approach to handling topics in a specific and uncommon manner was excellent. I hope they create more test publications in the future to make our lives easier.

User: Kodiak***** Passing the DEA-5TT2 exam is a significant achievement, and I was ecstatic when I passed with 87% marks. The credit goes to killexams.com for providing me with comprehensive and effective study material.

User: Vladimir***** There are not many DEA-5TT2 exam materials available, so I bought the DEA-5TT2 questions and answers in advance. Honestly, it won me over with the way the information was prepared. The majority of the questions I saw on the exam were exactly what was provided by killexams.com. I am relieved to have passed the DEA-5TT2 exam.

User: Joe***** Clearing the DEA-5TT2 exam seemed unrealistic to me at first because the exam factors were too extensive for me to comprehend. But then, I discovered Killexams.com and their Questions and Answers material, which helped me understand everything from the top to the bottom of the provided practice test. With the help of the exam simulator, I passed the exam successfully. I am grateful to Killexams.com for their incredible service.

---