DEA-5TT2 : Associate - Networking Exam

DEA-5TT2 Dumps DEA-5TT2 Braindumps
DEA-5TT2 Real Questions DEA-5TT2 Practice Test DEA-5TT2 Actual Questions
killexams.com
DELL-EMC
DEA-5TT2
Associate - Networking
https://killexams.com/pass4sure/exam-detail/DEA-5TT2
Question: 208
In which Spanning Tree protocol state does a port record MAC addresses but does not forward the data?
1. Forwarding
2. Blocking
3. Learning
4. Listening
Answer: C Question: 209
Which port type should be used for only VLAN-unaware devices?
1. Access port
2. General port
3. Hybrid port
4. Trunk port
Answer: A Question: 210
Which Ethernet frame forwarding method works best when the outbound ports run at the same speed as the inbound port?
1. Store-and-forward
2. Fragment-free
3. Unicast
4. Cut-through
Answer: D Question: 211
Which port type does a Dell EMC Networking N-Series switch have for its console connection?
1. DB9
2. RJ-45
3. USB A
4. USB B
Answer: A
Explanation:
Reference: https://downloads.dell.com/manuals/all-products/esuprt_ser_stor_net/esuprt_networking/esuprt_net_fxd_prt_swtchs/networking-n3100- series_user%27s-guide10_en-us.pdf page 197
Question: 212
Which type of domains are connected by a Layer 2 switch?
1. Single collision domain and a single broadcast domain
2. Multiple broadcast domains and multiple collision domains
3. Multiple collision domains and a single broadcast domain
4. Single collision domain and multiple broadcast domains
Answer: C Question: 213
Which component translates data, signaling, and protocols to facilitate the data flow between the end device and the network?
1. Switch
2. Transceiver
3. NIC
4. Port
Answer: C Question: 214
A network administrator created three VLANs on an Ethernet switch. How many broadcast domains are created by the switch?
1. 1
2. 2
3. 3
4. 4
Answer: C Question: 215
Which fields are mandatory TLVs in a LLDP PDU frame?
1. System Capabilities and Management Address
2. Chassis ID, Port ID, and Time-to-Live
3. IP Address, Default Gateway, and DNS
4. Port Description, System Name, and System Description
Answer: B
Explanation: Reference:
https://en.wikipedia.org/wiki/Link_Layer_Discovery_Protocol#:~:text=Each%20LLDP%20frame%20starts%20with,and%20length%20fields%20are%200
Question: 216
When configuring a switch, which CLI mode only supports limited show commands?
1. EXEC
2. Maintenance
3. Configuration
4. EXEC Privilege
Answer: D
Explanation:
When configuring a switch, the EXEC Privilege mode, also known as Privileged EXEC mode, only supports limited show commands. This mode provides elevated privileges for executing certain privileged operations and commands on the switch. It allows the user to perform tasks such as viewing system information, running diagnostic commands, and managing system configuration. However, it does not provide access to all show commands and configuration options available in the Configuration mode. To access the full range of show commands and make configuration changes, the user would need to enter the Configuration mode.
Question: 217
On which Dell EMC Networking switches can Multi-Chassis Link Aggregation (MLAG) be configured?
1. C9000 Series
2. N-Series
3. S-Series
4. Z-Series
Answer: B Question: 218
On which OSI layers do standard ACL filters operate?
1. 2 and 3
2. 2 and 7
3. 3 and 4
4. 4 and 7
Answer: C Question: 219
What is the Organizationally Unique Identifier (OUI) in the MAC address 00:C4:4F:23:AF:4A?
A. 00:C4:4F
B. 00:C4:4F:23
1. 23:AF:4A
2. 4F:23:AF:4A
Answer: A Question: 220
What are Network Address Translation (NAT) inside global addresses?
1. Addresses used by NAT router when sending frames to devices on the local network
2. Public IP addresses used by the local network to communicate with the Internet
3. Private IP addresses used by the local network
4. Pubic addresses used by other networks outside of the local network
Answer: B Question: 221
Which BASE-T Ethernet standard specifies a CAT6 cable type?
1. 2.5GBASE-T
2. 5GBASE-T
3. 10BASE-T
4. 10GBASE-T
Answer: D Question: 222
Which Dell EMC Networking M-Series 10 GbE switch model supports a VLT?
A. MXL B. M6220 C. M6348
D. M8024-K
Answer: A
Explanation:
Reference: https://i.dell.com/sites/doccontent/shared-content/data-sheets/en/Documents/PowerEdge_M_Series_Blades_IO_Guide.pdf
Question: 223
DRAG DROP
The IEEE separates the Data Link and Physical ISO layers into four sub-layers.
Based on the exhibit, what is the correct order of these sub-layers; from lowest to highest?
wrong Answer: A Question: 224
If a packet is sent to an IPv6 address and many devices receive the packet, what is this type of traffic?
1. Multicast
2. Broadcast
3. Anycast
4. Unicast
Answer: A Question: 225
You recently joined a company as a junior-level network administrator. You have been tasked with designing the IPv4 scheme for five networks that will be used for training classrooms. These networks need to support no more than 28 devices each. Due to the existing network design, the senior-level network administrator has asked you to work on network 192.168.40.0/24.
If all networks must be made to logically start with the lowest numbered network and end with the largest numbered network, what is the network ID for the third network?
A. 192.168.40.32/27 B. 192.168.40.64/27 C. 192.168.40.96/27 D. 192.168.40.128/27
Answer: B Question: 226
Which IPv6 scope is used for private addressing on a local network?
1. Global
2. Area wide
3. Unique local
4. APIPA
Answer: C Question: 227
What is the default OSPF âhello intervalâ?
1. 5 seconds
2. 10 seconds
3. 15 seconds
4. 30 seconds
Answer: B

User: Mathew***** I took advantage of the practice tests provided by killexams.com, which were rich with information and effective content that I was looking for in my preparation. The material boosted my confidence and provided me with the self-assurance to take my associate - networking exam. The material was so close to the actual exam questions that, as a non-native English speaker, I completed the exam in 95 minutes instead of the allocated 120 minutes. Thank you for the excellent practice test.

User: Vanya***** I feel very confident in my dea-5tt2 certification, thanks to the preparation I did using the questions and answers provided by the Killexams.com team. This was my first time using their products, and I used the exam simulator software to prepare for the exam. The preparation was very thorough, and I did not omit any topics from the authentic syllabus. I passed the certification exam with ease, and I highly recommend the Killexams.com exam simulator.

User: Molly***** After practicing with Killexams.com for a few weeks, I passed the DEA-5TT2 exam. The questions and answers provided were accurate, and I was able to answer the questions easily because they were taken from the real exam. Thanks to Killexams.com, I was able to score higher than I had hoped for, and I am relieved to have passed the exam.

User: Alba***** After failing the dea-5tt2 exam for the first time, I felt like I was on my own. I searched the web for test help and found many websites offering practice exams for around $200. Killexams.com was the lowest-priced option, and even though I could not afford it, I decided to give it a shot. To my surprise, I passed my certification exam with a 98%! Killexams.com provided nearly every question on the exam, making them stand out in my book. I would gladly offer a testimonial for this successful resource.

User: Savya***** Thanks to the Killexams.com set, I passed the DEA-5TT2 exam after a few days of preparation. The correct questions and answers in the bundle made things a lot easier, and I got a score higher than I had hoped for. I am relieved to have left the exam behind but happy to have found Killexams.com.

---